It’s alive! – kind of. MGN12 Rails update

Well, the MGN12H linear rail carriages fit into the new carriage adaptors I quickly knocked up in Tinkercad perfectly!

And, don’t they look lovely in Purple (great filament from 3D Filaprint)

Now, to dismantle the printer and see if the print bed tray fits…………

That’s the problem with printing stuff to upgrade a printer, iterating takes time and stuff gets dismantled waaay too much! I need a second printer :-p

V Slot Wheels / Bearings – Highly recommended Upgrade

Wheels – Bearings – they’re critical, load supporting and a highly recommended, immediate upgrade for your printer….only 6 are critically needed – 9 will upgrade the Y and X axis – if you’re feeling flush, 15 will do the whole printer!

The V slot wheels on the Y axis that came with my Duplicator 9 were a bit squished in transit…I tried to squish them back together but it quickly became clear that these weren’t quite circular and had an eccentric wobble that transmitted up to the Y build plate.

I tried a few times to use the printer, but the build plate would quickly sag at the rear, making the plate off level to the point where it interfered with and hit the rear microswitch!

 

I guess I needed new ones

Continue reading “V Slot Wheels / Bearings – Highly recommended Upgrade”