Wanhao Duplicator D9 – MK10 Extruder issues – Teardown and….a 3D model

After having a few minor issues with filament slipping and prints generally being a bit crappy, I figured I’d take stuff apart, always helps me relax…

On the interwebs I was really unable to find any specific detail about the MK10 / MK11 type head that the Wanhao Duplicator 9 uses…

Continue reading “Wanhao Duplicator D9 – MK10 Extruder issues – Teardown and….a 3D model”

Calibration – Part 2……Again!

280 x 280mm

https://www.thingiverse.com/thing:2479352/

After figuring out that 20mm, just ain’t good enough to calibrate, I had a nose around on thingverse….

The largest ‘calibration’ thing I found was the above 280 x 280mm square……..Awesome, that’s good enough, close to 300mm too for maximum calibratory goodness…

Continue reading “Calibration – Part 2……Again!”