After figuring out that 20mm, just ain’t good enough to calibrate, I had a nose around on thingverse….
The largest ‘calibration’ thing I found was the above 280 x 280mm square……..Awesome, that’s good enough, close to 300mm too for maximum calibratory goodness…
Continue reading “Calibration – Part 2……Again!”
Lots of basic printing suggested that the front to back measurement was slightly off…so, finally I’ve decided to calibrate the printer….
By, printing a calibration cube! I’ll do it a little differently and record just a bit more information…I’ll measure 3 points for each axis, giving 9 points for the cube….
Continue reading “Calibration – WYISYG, Don’t use a 20mm Cube for accuracy!”