Been reading way too many maker blogs. Here's my contribution
Anycubic Photon Mono-X 90 Degree dripper
Very early days yet on this design. A couple of hours of measuring and sketching in Fusion360. Needs some finessing, but the principle is sound.
Given 90% of my printed things are quite short, (keyboards, Mini computer case prototypes and miniature monsters) I can comfortably make a very efficient 90 Degree bed resin drip drainer and keep the cover on!
Most drainers are maybe 20-40 degrees or so!
The new Drainer bracket in Yellow – Sits permanently on the printerAnd, the position of the bed when it’s rotated 90 Degrees. The Yellow bracket and the original ‘stick out bed holder’ clamp the bed sideways between then! The ‘curve’ bit stops the bed sliding too much to the right and ‘off’.
Early Fourties, Wife, two kids in primary school. Both of us work full time...5 years now we’ve been Back in Blighty after a decade away...It's a new country for everyone! Still finding time to tinker!
View all posts by Bleugh
Bleugh.Biz Blog Thingy 