Got me a little tweakin’ time today –



Have spent a few hours fine tuning alignments – with the new ‘underneath’ mounting of the solderless Blinkenator trial, some of the alignment changes.
The J15 Connector shifts away from the edge about 3/4 mm due to the curvature of the next case, which also needs the larger pillar holes to be moved and increased in size a little.


The print fitted almost perfectly, slight misalignment with J15, I’ll probably make the two locating holes a little larger to allow a little play. The 3D print won’t be the exact same dimensions as the manufactured PCB but it’s close enough to see what tweaks are needed.
And, finally an update on the new next is at Kickstarter!!
https://www.kickstarter.com/projects/spectrumnext/zx-spectrum-next-issue-2/posts/3224494