Follows a couple of pictures of the install, I’ve also put a couple of videos up on youtube. More will follow

DIODE orientation. Note, make sure they’re all the same way round. One here isn’t!
I’ve put some videos up on youtube about the assembly process – the playlist is linked below

Putting the switches in Wonky for the first round of alignment (smt diodes hand soldered on the original prototype)

Make sure you solder the arduino headers on before you get this far with the switches

Back of board showing Diode legs clipped and only ONE switch pin tacked per switch
USB HUB TO FOLLOW – Pictures shown in blog previously if you need them quickly