Did an attempt at a jig to make hacking up your own keyboard just a little easier….
it’s fairly easy to hack up the existing keyboard into bits….(get hacky thingy, cutty thingy, hack, cut…maybe smooth off burrs if you’re feeling artsy)
Getting the brand new hacked up bits of plastic that once looked like a keyboard to sit straight on the switches and resemble the previous keyboard resemblance …..not so much.
Turns out that making things ‘straight’ is hard……..so, some ideas
3D design and print new keycaps with locking mechanisms that work with my chosen keyswitches (still onging, it’s been MONTHS of work)
My first other idea…….. create a form to fill with plaster of paris, press the plastic full keyboard into that form, leave to set…
Remove keyboard and admire a perfect negative image of the keyboard.
Two things that could be done with this
Use that plaster of paris as a form to create resin keycaps (without any lettering) – I’m working on that!
second – it can be used as a perfect ‘form’ to sit the newly butchered keycaps in, fill with epoxy glue, sit keyboard PCB on top and let the keycaps become glued on, all nice and straight like!
it’s fairly easy to export the keyboard PCB outline from EasyEDA as a DXF then import to Fusion, extrude and…voila!
But…There’s an ever so tiny mistake in the image above
That’s the printed version…The holes line up great!
Yeah, the keyboard should be face down!, D’oh!
i’ll see if the snips’ll work
The other thing….
Fits like a glove….
Nice and snug – Note the top row of keys is level…..
Some small design work needed but the idea has promise!. I just need to re-jig the hole widths a little to accommodate the angle of the keyboard better!
I’ve purchased another couple of C64 Minis so that I can improve this jig more. I’m not quite certain where the keys will ‘fall’ once they’re seperated from the base of the plastic moulding.
The more I think about it, i’m thinking that there could be a shedload more work in this jig – one ‘saving grace’ though – due to the way injection moulding works – there’s a slight taper on the existing fake switches. And, I suspect that the rear of them has been modded so that they’re almost perpendicular to the base. this will help the whole mould ‘pop off’ the injection machine…
That also helps me with this jig as it really means that, at the base of the keys, all the keys seem to have the same uniform rear rising, almost perpendicular taper and front curving taper. kinda like the below diagram
That could turn the whole change into just re-extruding the jig key holes at the 8 degree angle of the keyboard as above……..