My printer / PC should be back up and running on the weekend, based on some feedback from a trial tester, I’ve modded the brackets a little – namely to improve the ease of removing of the supports in the stepper motor part , and increasing the height a little for the idler mount on the right…
Some more tweaks will happen before I get to properly print and test, then I’ll upload
Above shows the lines inserted in the NEMA17 stepper motor mount. This should negate any need to use supports
Small raising of the idler mount by 3mm. Has to be tapered to allow the bracket to print properly!
And, finally, some sample print pictures, Thanks Aaron