D9 Printer Bed Levelling – Done Right

 

bed-leveling-on-Ultimaker2-1.jpgFinally – Wanhao have released a decent firmware – V0.164(B)

Now, Levelling the bed…..

 

There’s LOADS of videos, methods ,etc out there….this way is SIMPLE, CONSISTENT and reliable

Make sure your printer head is clean and free from cooled plastic

MAKE SURE THE BED IS CLEAN...(I’m using baby wet wipes, but they dont’ seem to be the best, i’ll need to try isopropyl alcohol like the old timers are)

How to clean….Use a sponge, soap and water………that’s it!

1 – LEVEL the Z axis – use a ruler / visual marks on the back, whatever, make sure the bar is level

2 – Use the menu to go into  the LEVEL selection

3 – Get the Z axis offset correct by using a piece of paper so it’s just gripped by the head

4 – TURN OFF THE PRINTER (yes, TURN IT OFF, DO NOT CLICK NEXT)

5 – MANUALLY move the print head to CLOSE (maybe 10mm away from) to the corners…

  • Start on one corner – use the paper between the head and the bed…adjust the screw in that corner till it just grips.
  • Move to the next corner, repeat
  • repeat again
  • repeat again

6 – Go back and check each corner and tweak slightly if necessary

7 – Turn printer on and LEVEL THE BED IN SOFTWARE AS NORMAL……

 

Now, if you really want to be pedantic, you should do this whilst everything’s warmed up to your normal working temperatures!

That’s it, the end

 

 

 

 

Author: Bleugh

Early Fourties, Wife, two kids in primary school. Both of us work full time...5 years now we’ve been Back in Blighty after a decade away...It's a new country for everyone! Still finding time to tinker!

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s

%d bloggers like this: